 |
 |
 |
|
|
|
[Sponsors] | ||||
May 17, 2020, 15:35
|
Streamlines are not evenly spaced
|
#1 |
|
New Member
AKINPELU Akorede David
Join Date: Nov 2016
Posts: 4
Rep Power: 10  |
I am trying to generate streamlines of a flow around an elliptical cylinder.
I used the `stream tracer` filter, but the streamlines are not evenly spaced. Looking at the image attached below, there are more streamlines on the left side of the domain than on the right side. How can I make the number of streamlines on both sides the same? |
|
|
|
|
|
May 22, 2020, 15:48
|
|
#2 |
|
New Member
AKINPELU Akorede David
Join Date: Nov 2016
Posts: 4
Rep Power: 10 |
I used OpenFoam, but I can see you are using Ansys. They are two different Softwares. In OpenFoam, I noticed I specified a wrong line parameter in the streamTrace properties.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Exporting coordinates of 3D streamlines (Wave rider) for CAD Model | Nitish_kamal | FLUENT | 1 | November 4, 2019 06:39 |
| Concentrated Streamlines versus Higher Velocity | eucalyptus | Main CFD Forum | 1 | October 27, 2017 12:54 |
| Interpreting streamlines of a rotating fan. | danbence | Visualization & Post-Processing | 1 | April 8, 2014 11:13 |
| [General] Problems with streamlines for 2D porous media flow simulations | twophaseflow | ParaView | 4 | February 11, 2014 15:32 |
| STAR-CD, moving grid and streamlines | Mohamed GUEROUACHE | Main CFD Forum | 1 | September 13, 1999 14:33 |
Linear Mode
