[General] Paraview does not show the blocks in the flume -- CFD Online Discussion Forums

February 21, 2019, 20:45	Paraview does not show the blocks in the flume	#1
shimakasaei Member shima Join Date: Feb 2018 Posts: 58 Rep Power: 8	Hi I did run my simulation with olaFlow solver and I used snappyHexMesh for generating the mesh area. when it finishes the simulation, and I want to check my flume, paraview doesn't show me the blocks in the flume although the folders are written in time intervals!! I do not know what is wrong with it and where I am doing wrong?? I will appreciate if anyone can help. Best, Shima.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFD post cannot load results-Error appeared?	mariam.sara	ANSYS	9	September 17, 2018 16:23
[OpenFOAM] paraview does not show any figures	babakflame	ParaView	0	April 4, 2018 12:23
[mesh manipulation] Combining multiple mesh blocks	ingojahn	OpenFOAM Meshing & Mesh Conversion	1	August 18, 2014 04:19
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12	keepfit	ParaView	60	September 18, 2013 04:23
[OpenFOAM] ParaView 340 experience Does not show animation	eno	ParaView	10	November 14, 2008 13:38

All times are GMT -4. The time now is 03:14.