 |
 |
 |
|
|
|
[Sponsors] | ||||
[OpenFOAM] paraFoam: how to load a specific range of solution ? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 12, 2018, 17:08
|
paraFoam: how to load a specific range of solution ?
|
#1 |
|
Senior Member
Join Date: Mar 2018
Posts: 115
Rep Power: 8  |
Hello
To post processs an OpenFOAM simulation I use paraview. Because the case is very big it takes a long time to load in paraview. The transient simulation time is from t = 0 to t = 50 with Dt = 0.001. How can I tell paraview to load solution only between t=10 and t=25 ? |
|
|
|
|
|
August 8, 2018, 11:15
|
|
#2 |
|
New Member
Join Date: May 2018
Posts: 14
Rep Power: 8 |
Delete the folders between t=0.001 and t=10 or move them in an other place.
|
|
|
|
|
|
|
| Tags |
| paraview |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The udf of specific heat can load but leading the case divergence | Kobe Peng | Fluent UDF and Scheme Programming | 2 | July 8, 2018 20:11 |
| Simple piston movement in cylinder- fluid models | arun1994 | CFX | 4 | July 8, 2016 03:54 |
| AMI memory leak? | MichiB | OpenFOAM Programming & Development | 14 | August 1, 2015 19:18 |
| Distribution model to inject particles of two specific sizes only (not a range) | ansubru | OpenFOAM Running, Solving & CFD | 1 | June 15, 2015 19:17 |
| [OpenFOAM] What's the minimum range in paraFoam? | Kabra | ParaView | 0 | April 9, 2015 14:00 |
Linear Mode
