|
[Sponsors] |
[OpenFOAM] Using ASCII rather than binary VTK format because floatScalar and/or label are .... |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 22, 2017, 21:58 |
Using ASCII rather than binary VTK format because floatScalar and/or label are ....
|
#1 |
Senior Member
TWB
Join Date: Mar 2009
Posts: 414
Rep Power: 19 |
Hi,
After running openfoam5, I use reconstructPar and foamToVTK to construct back and convert the data to VTK. I got the error msg: Using ASCII rather than binary VTK format because floatScalar and/or label are not 4 bytes in size What's the problem? My openfoam was admin installed but I don't remember having this problem before when I'm using openfoam3. So what can I do and what should I change? My data can be quite big so I hope to use binary if possible. Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Resolved] GPU on Fluent | Daveo643 | FLUENT | 4 | March 7, 2018 09:02 |
[General] Paraview data format conversion from vtk to parallel prog data format. | odho | ParaView | 0 | September 20, 2016 08:01 |
Error in solution using "Grid Interface" | agustinvo | FLUENT | 4 | January 20, 2015 13:03 |
HashTable Binary write format | deepsterblue | OpenFOAM Bugs | 1 | March 16, 2010 11:03 |
Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 09:42 |