 |
 |
 |
|
|
|
[Sponsors] | ||||
August 15, 2017, 22:22
|
ParaView startup
|
#1 |
|
New Member
Lucas Gasparino
Join Date: Jul 2017
Location: Swansea, UK
Posts: 23
Rep Power: 9  |
Hello!
I've tried installing ParaView 5.4.0 on my Win8 machine, but, although the install was sucessful, it produces an error message that GLEW could not be started and thensimply doesn't work: draging the error box produces a trace image that doesn't disapper. I'm attaching a print of my screen. My video card is... old. It's a Radeon M265X with the latest drivers available and 2GB VRAM. Even SolidWorks runs fine on it; in fact, only ParaView refuses to run properly. Any suggestions, or someone with a similar problem? Thank you very much! |
|
|
|
|
 |
| Tags |
| error, glew, paraview 4.2 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] Two different versions of ParaView with same OpenFOAM release | FJSJ | OpenFOAM Installation | 2 | July 23, 2017 06:48 |
| Installing OpenFOAM and ParaView in VirtualBox(Ubuntu on Win8) | chrisb2244 | OpenFOAM Installation | 2 | August 21, 2013 14:24 |
| Newbie: Install ParaView 3.81 on OF-1.6-ext/OpenSuse 11.2? | lentschi | OpenFOAM Installation | 1 | March 9, 2011 03:32 |
| paraFoam reader for OpenFOAM 1.6 | smart | OpenFOAM Installation | 13 | November 16, 2009 22:41 |
| [OpenFOAM] Paraview cannot startup | gnom | ParaView | 6 | October 14, 2009 01:30 |
Linear Mode
