|
[Sponsors] |
[OpenFOAM] Different Initial values in Paraview |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 28, 2017, 17:38 |
Different Initial values in Paraview
|
#1 |
Member
Fredi Cenci
Join Date: Dec 2016
Posts: 38
Rep Power: 9 |
Hello guys,
I am performing an external unsteady flow using pisoFoam. I set k, omega for the internal mesh and inlet, however when I see these values in paraview it doesn't match. Example: k is zero in the mesh and 3 on the inlet, and I did set k as 3.78e-9 for inlet and internal mesh. Omega is zero in inlet and internal mesh, and I did set as 0.3765. Could someone explain why is it happening? Thanks a lot. |
|
March 28, 2017, 18:14 |
|
#2 |
Member
Fredi Cenci
Join Date: Dec 2016
Posts: 38
Rep Power: 9 |
I used the command paraFoam & instead open from paraview.. It worked!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HeatSource BC to the whole region in chtMultiRegionHeater | xsa | OpenFOAM Running, Solving & CFD | 3 | November 7, 2016 05:07 |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 02:20 |
Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 18:17 |
pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 03:34 |