|
[Sponsors] |
[General] Using "Threshold Filter" with "Integrate Variables" |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Konstantin
Join Date: Jun 2015
Posts: 8
Rep Power: 11 ![]() |
Hello everybody!
I had a problem with the complex using of two filters - "Threshold Filter" and "Integrate Variables". For now I'm trying to use "Threshold Filter" to extract concentration of fluid (alpha) in computational domain (2D). So, it work's great. By next step, I apply "Plot over line" filter to extract some line on this "Threshold Filter". So, it work's) But, on the next step, when I apply "Integrate Variables" of this "Plot" on "Threshold", I have "nan" value for parametres like "Ux, Uy, alpha, p". You can see my problem on screenshot. What I need to do to make it work? Best regards, DzhoniD) |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] threshold filter: irregular border of image | WhiteW | ParaView | 4 | December 29, 2015 17:18 |
[General] IntergateVariables filter. How to select variables to integrate? | Antech | ParaView | 0 | June 4, 2015 02:38 |
[General] "Integrate Variables" and "Plot Selection Over Time" fail | haakon | ParaView | 2 | April 20, 2015 18:22 |
the integrate filter paraView | bruxellois | OpenFOAM | 0 | October 3, 2010 18:08 |
[OpenFOAM] 'integrate variables' filter on a polyhedral mesh gives wrong results... | jbf | ParaView | 0 | September 4, 2009 04:08 |