[General] streamlines and cyclic boundaries -- CFD Online Discussion Forums

August 25, 2016, 15:52	streamlines and cyclic boundaries	#1
vbchris Member Chris L Join Date: Sep 2012 Posts: 53 Rep Power: 14	Has anyone rebuilt cyclic geometries in paraview and applied streamlines with success? My geometry is a 45 deg wedge with cyclic boundaries and paraview only applies streamlines to a single wedge. Is there a method to apply streamlines to all wedges in a geometry so the streamlines are continuous across cyclic boundaries?. Or maybe there is a tool/method for reconstructing cyclic meshes before importing into paraview? Thanks in advance for any advice.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rotating Mesh, errors in Cyclic AMI interface	WhiteW	OpenFOAM	2	September 26, 2016 10:12
[OpenFOAM] Streamlines through cyclic patches in Paraview	kornickel	ParaView	3	January 28, 2016 07:59
StreamLines crossing cyclic patches	jlobera	OpenFOAM Programming & Development	0	October 19, 2015 11:08
Wall bounded values and streamlines	Ruli	OpenFOAM Post-Processing	5	February 2, 2014 17:45

All times are GMT -4. The time now is 11:19.