|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
chathu
Join Date: Apr 2016
Posts: 3
Rep Power: 10 ![]() |
Suppose i have a set of images, where those images are segmented and saved in the .vtk format. Kindly note that these segmented images differ in size though they are in the same set.
My question is: can i open each .vtk file separately, then stack and build a 3D model inside ParaView. Or else, can you please shed a light of how to construct a 3D model which are different in sizes and in the vtk format Thank you in advance (note: i am new to Paraview,, so i apologize if this question have been asked before which i did not come across with) |
|
![]() |
![]() |
![]() |
Tags |
3d model |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transient Phase Change Model: Explodes at low vapor quality | evcelica | CFX | 0 | August 28, 2018 10:55 |
Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 17:38 |
Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
manualInjection model in sprayFoam | Mentalo | OpenFOAM Running, Solving & CFD | 1 | April 2, 2014 09:29 |
Problems bout CFD model of biomass gasification, Downdraft gasifier | wanglong | FLUENT | 2 | November 25, 2009 23:27 |