[StefanW]

Dear Foamers,

i got a problem according showing the right data in paraview 3.10 and hope somebody can help me.

I simulate a pipe (OF 2.0.1) which walls are going to be cleaned by sending in water with high velocity.

To make the cleaning effect visible, I implemented some stuff in the solver which calculates me the wall shear stresses. To evaluate the sucess I wanna figure out (for all the wall cells of the pipe) what is the maximum of shear stress archieved at each point within the whole simulation time.

I played arround with Filters like "Extract Surface" "Find Data" "Descriptive Statistics", but it always allows me kind of a plot for a small region or just one timestep.

I dont need implicitly a plot it would be ok to have the "normal" 3D-graphics of paraview with all the maximums.

Is there a way to do this in the GUI, or do you guess i have to manipulate the input data first? If yes, what would be the easiest way to do this from your point of few.

Would be great if someone could help me!

Thank you in advance.

Best Regards
Stefan

[StefanW]

nobody any idea?