[General] Paraview 5 does not work on a .py created by trace

blabhblah_gc · February 2, 2016, 20:23

Hi

Not sure where I am missing. I used Paraview 5.0, turned on trace, open a file, turned off trace. A test.py is created. Then I use pvpython test.py, nothing shows up. Then I had to uncomment "RenderAllViews()" in test.py, I can see paraview flashes 1/10 of a sec.

Does anybody know where I am missing?

thanks

blabhblah_gc · February 5, 2016, 17:56

Can someone pls help? Is it that I did something obviously wrong? Or I am not describing my problem clearly. All I did was to backfeed the generated .py back to Paraview using "pvpython" . Thanks

February 2, 2016, 20:23	Paraview 5 does not work on a .py created by trace	#1
blabhblah_gc New Member Join Date: Jan 2016 Posts: 6 Rep Power: 10	Hi Not sure where I am missing. I used Paraview 5.0, turned on trace, open a file, turned off trace. A test.py is created. Then I use pvpython test.py, nothing shows up. Then I had to uncomment "RenderAllViews()" in test.py, I can see paraview flashes 1/10 of a sec. Does anybody know where I am missing? thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie: Install ParaView 3.81 on OF-1.6-ext/OpenSuse 11.2?	lentschi	OpenFOAM Installation	1	March 9, 2011 03:32
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 16:45
Paraview installation troubles	jjhall	OpenFOAM Installation	3	April 17, 2008 13:59
[OpenFOAM] Why dosnbt it work on paraview when inputing the results of the case tutorialsstr	dandes	ParaView	3	March 22, 2006 12:06
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19

February 5, 2016, 17:56		#2
blabhblah_gc New Member Join Date: Jan 2016 Posts: 6 Rep Power: 10	Can someone pls help? Is it that I did something obviously wrong? Or I am not describing my problem clearly. All I did was to backfeed the generated .py back to Paraview using "pvpython" . Thanks