|
[Sponsors] |
[General] Issue in aspect of two equal surfaces |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 4, 2015, 03:15 |
Issue in aspect of two equal surfaces
|
#1 |
New Member
Join Date: Nov 2015
Location: GER
Posts: 10
Rep Power: 10 |
Hello again,
I would like to visualize a geometry and its fill as slice. The uncomely thing about this is, that the surfaces are of course the same. So ParaView tries to show both of them which means that the geometry has some block size overlappings of the fill. Is it possible to force the geometry to be shown or maybe shrink the fill a little? Regards, cfdFreshman |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to get two sided surfaces | sebbel | CFX | 1 | November 16, 2018 02:45 |
NURBS surfaces on a wing | frossi | CFX | 5 | February 5, 2017 15:27 |
Specifying points for sampling surfaces in sampleDict | arieljeds | OpenFOAM Post-Processing | 0 | April 20, 2016 07:11 |
[ICEM] Issue creating geometry and trim surfaces | M4x1m | ANSYS Meshing & Geometry | 1 | February 9, 2015 08:38 |
Normal vector, slope and aspect angle | g_niro | Main CFD Forum | 0 | February 2, 2011 17:24 |