 |
 |
 |
|
|
|
[Sponsors] | ||||
May 21, 2015, 15:10
|
Navigate along the object
|
#1 |
|
Senior Member
Thomas Oliveira
Join Date: Apr 2015
Posts: 114
Rep Power: 12  |
Hi,
I am visualizing a cube in which there are many channels like wormholes. I would like to navigate inside the cube along the channels, turning left, right, up and down, and "walking" forward and backward. Do you know if it is possible to do so on Paraview? EDIT: Apparently there was a FlyIn and FlyOut movement, according to this manual: http://vis.lbl.gov/NERSC/Software/pa...a_controls.htm Where is it now (ParaView 4.1.0)? Thank you, Thomas Last edited by t.oliveira; May 21, 2015 at 16:40. Reason: Found new information |
|
|
|
|
 |
| Tags |
| navigation |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| error in fireFoam, when running the case wallFireSpread2D | zhoubiao1088 | OpenFOAM Running, Solving & CFD | 9 | February 1, 2018 19:45 |
| [foam-extend.org] Error compiling OpenFOAM-1.6-ext | Canesin | OpenFOAM Installation | 137 | January 20, 2016 15:56 |
| [OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 04:23 |
| Compilation error OF1.5-dev on Suse10.3 | darenyang | OpenFOAM Installation | 0 | April 29, 2009 05:55 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 08:36 |
Linear Mode
