[MarkHerskind]

Hi..

I'm very new to ParaView, so this may be a simple question...

I'm displaying results from a Ansys CFX simulation (exported as CGNS) of flow over terrain..
I can't seem to isolate the ground-surface (I can't find anywhere to do this?!), so instead, I'm importing the ground surface from a XYZ-file (Using tableToPoints and Delauney2D).. This works fine for visualizing the ground..

I would like to make a surface at a offset from the ground (say 80m above ground) and on this surface I would like to display values (eg velocity) from the CGNS-file..

My pipeline looks as in the attached file..

Any help would be greatly appriciated..

I'm using ParaView 4.2.0 64Bit for Windows..