|
[Sponsors] |
[General] "Save Data" from "Plot Over Line" for a single type of data |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Senior Member
Canakkale Dardanelspor
Join Date: Aug 2012
Posts: 135
Rep Power: 14 ![]() |
Hi
== 1 == I would like to extract a single type of data into a .csv file via "File -> Save Data". == 2 == The data is obtained by utilising "Plot Over Line". == 3 == When "File -> Save Data" is used, paraview exports all available data types values on the line. I, however, would like to extract only, say, UMean vs. arclength. == 4 == Although I deactivated all the other variables in the "Line Series" of the "Plot Over Line", paraview saves all the line series into the .csv file. == 5 == Many thanks for any help in advance. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
qutadah
Join Date: Jun 2021
Location: USA
Posts: 101
Rep Power: 5 ![]() |
i know its an old post, but passArrays filter helps filter what you just need.
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
activeBaffleVelocity boundary condition ? | om3ro | OpenFOAM Programming & Development | 10 | November 16, 2020 23:26 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Modified pimpleFoam solver to MRFPimpleFoam solver | hiuluom | OpenFOAM Programming & Development | 12 | June 14, 2015 21:22 |
[General] 2 datas on one plot | Akuji | ParaView | 46 | December 1, 2013 14:06 |
singularity? | mihaipruna | OpenFOAM Running, Solving & CFD | 5 | April 24, 2012 17:18 |