|
[Sponsors] |
[OpenFOAM] Plotting the averages on section cuts |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 2, 2014, 08:47 |
Plotting the averages on section cuts
|
#1 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128 |
I answered today to a private message on the topic of the title. The objective is to do the averages (integrate) on each section-cut and then plot all of the averages in a single graph.
You can use ParaView to do the following steps:
Note 2: ParaView does allow making several section cuts in a single entry, by using the offsets list. The problem is that the "Integrate Variables" will integrate it all into a single point. Best regards, Bruno
__________________
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Identifying Markers in a CGNS Mesh | tjim | SU2 | 3 | October 12, 2018 01:21 |
[Commercial meshers] converting Fluent mesh to openfoam standard mesh | deepesh | OpenFOAM Meshing & Mesh Conversion | 31 | March 29, 2017 05:59 |
dsmcInitialise - dsmcFoam | archymedes | OpenFOAM Pre-Processing | 94 | July 15, 2016 16:14 |
[Other] How to create an MRF zone ? | aminem | OpenFOAM Meshing & Mesh Conversion | 2 | December 8, 2014 10:45 |
making wing section cuts in Fluent? | mimi | FLUENT | 0 | May 8, 2007 03:42 |