[General] export picture messy problem

chenxizh · January 6, 2014, 05:19

Hi, all , I have a problem when I load paraview in Linux and export the picture, the picture seems messy. However when I did it in Windows system, everything is right. Do anybody face the same problem before? How to solve it ? Thanks.

Following is the picture from Linux and windows system as an exmple.
linux.jpg

windows.jpg

wyldckat · January 10, 2014, 16:38

Greetings chenxizh,

It's very possible that you are having problems with the graphics driver. Perhaps you haven't installed the correct one in your Linux system?

Knowing more about your set-up would make it easier to help you. For example:

Which Linux distribution are you using? And which specific version and architecture?
Which ParaView version are you using?
How did you install ParaView?
Did you install the drivers for the graphics card?
Do you know which graphics card you have in your machine?

Best regards,
Bruno

January 6, 2014, 05:19	export picture messy problem	#1
chenxizh Member chenxizhong Join Date: Feb 2012 Posts: 30 Rep Power: 14	Hi, all , I have a problem when I load paraview in Linux and export the picture, the picture seems messy. However when I did it in Windows system, everything is right. Do anybody face the same problem before? How to solve it ? Thanks. Following is the picture from Linux and windows system as an exmple. linux.jpg windows.jpg

January 10, 2014, 16:38		#2
wyldckat Retired Super Moderator Bruno Santos Join Date: Mar 2009 Location: Lisbon, Portugal Posts: 10,981 Blog Entries: 45 Rep Power: 128	Greetings chenxizh, It's very possible that you are having problems with the graphics driver. Perhaps you haven't installed the correct one in your Linux system? Knowing more about your set-up would make it easier to help you. For example: Which Linux distribution are you using? And which specific version and architecture? Which ParaView version are you using? How did you install ParaView? Did you install the drivers for the graphics card? Do you know which graphics card you have in your machine? Best regards, Bruno

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM.org] blockMesh issue on openfoam6 startup - ubuntu 16.04	bjdarrer	OpenFOAM Installation	7	August 25, 2020 20:15
[OpenFOAM.org] Compiling OpenFOAM 5.0 on the Titan Supercomputer	wildfire230	OpenFOAM Installation	20	May 6, 2020 08:30
A CFX-POST error (ver 14.5.7)	wangyflp88	CFX	2	July 22, 2017 01:17
[ICEM] problem export 2d geometry	Marcuse	ANSYS Meshing & Geometry	7	January 26, 2015 15:34
CFX Post export problem	jeff_F	CFX	0	August 17, 2009 22:25