[General] reading tecplot time data in a single file -- CFD Online Discussion Forums

March 17, 2013, 21:12	reading tecplot time data in a single file	#1
canopus Member SM Join Date: Dec 2010 Posts: 97 Rep Power: 15	Hi I have written the output from my CFD code in tecplot format. Since tecplot licenses are few at my place I want to read them in paraview. The data is of a 2D plane written over several time steps in a single filein ASCII format. I could read in the data in paraview but do not know how to separate the time data to make animation. The whole thing is lumped in as Multiblock dataset. However the separate data sets are labeled by the time which was also written in file. I could isolate each of them by using filter extractblock but how to do animation? Please advise. Thanks

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field	lakeat	OpenFOAM Community Contributions	58	December 23, 2021 03:36
OpenFoam "Permission denied" and "command not found" problems.	iyidaniel@yahoo.co.uk	OpenFOAM Running, Solving & CFD	11	January 2, 2018 07:47
what is swap4foam ??	AB08	OpenFOAM	28	February 2, 2016 02:22
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam)	cfdonline2mohsen	OpenFOAM	3	October 21, 2013 10:28
[swak4Foam] build problem swak4Foam OF 2.2.0	mcathela	OpenFOAM Community Contributions	14	April 23, 2013 14:59

All times are GMT -4. The time now is 18:35.