[General] How to display the chamber wall surface in light color when 3D contours are plotted ? -- CFD Online Discussion Forums

December 2, 2012, 19:36	How to display the chamber wall surface in light color when 3D contours are plotted ?	#1
hz283 Senior Member Join Date: Nov 2012 Posts: 171 Rep Power: 14	Hi All, I am using paraview to visualize the contous of the flow in a chamber. However, I do not know how to *make the wall surface (not only the lines) displayed in a very light color* (e.g. gray) in the figure. I know tecplot can do this. Is there anybody who can give me some hints about this issues? Thank you very much. best regards, hz

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
surface heat transfer coeff of wall flux	rsa	FLUENT	0	June 1, 2016 10:40
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 03:09
[snappyHexMesh] Problem with snappyhexMesh: modelling a pore chamber and pore throat model	Saideep	OpenFOAM Meshing & Mesh Conversion	5	May 10, 2015 15:46
free surface display	carno	Siemens	4	October 7, 2005 02:03
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 06:12

All times are GMT -4. The time now is 22:07.