|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Bin Xu
Join Date: Apr 2012
Location: Singapore
Posts: 23
Rep Power: 14 ![]() |
Hi good morning everyone, I have a U-shaped elbow in hand now, i just finished calculation, now come to the postprocess step, when i cut a plane, it always has two circles, how can i only have one circle (e.g for outlet) only. Many thanks and best regards.
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] faceSet of a cutting plane for a internal patch definition | RubenGutiii | OpenFOAM Meshing & Mesh Conversion | 1 | April 17, 2019 05:10 |
Measure the surface of the faces of a triangulated cutting plane | Pagoda | OpenFOAM Post-Processing | 3 | August 20, 2018 09:51 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Curiosity & Question about cutting plane through axisymmetric region | aerospain | OpenFOAM Post-Processing | 0 | October 4, 2012 04:05 |
plane cutting complex geometry in the middle | Lilly | FLUENT | 0 | July 27, 2011 09:01 |