OpenFOAM

Rating Thread / Thread Starter	Last Post	Replies	Views
Sticky: Getting Started with OpenFOAM ( 1 2) wyldckat	June 21, 2024 07:54 by Martin_Sz	26	52,881
Sticky: OpenFOAM.com versus OpenFOAM.org: Which version to use? wyldckat	March 25, 2023 08:50 by ancolli	19	63,879
Sticky: Map of the OpenFOAM Forum - Understanding where to post your questions! wyldckat	September 2, 2021 06:29 by hakosaj	10	22,138
Sticky: How to contribute to the community of OpenFOAM users and to the OpenFOAM technology wyldckat	November 10, 2017 16:54 by rdbisme	17	21,157
Sticky: How to give enough info to get help linnemann	September 20, 2017 10:19 by linnemann	8	56,886
Sticky: Wiki ( 1 2 3 ... Last Page) gschaider	December 31, 2014 08:34 by wyldckat	178	69,410
spliting the domain REJISH	April 16, 2014 10:09 by REJISH	9	2,030
masterthesis Water/Air spray tharkus	April 16, 2014 02:38 by amkokko	4	3,345
I dont know if its suitable to post this: who are there bug fixer? sharonyue	April 15, 2014 22:47 by sharonyue	4	1,529
surface sampling with a step smaller than outputTime seiji_adachi	April 15, 2014 05:44 by adarsh tiwari	3	1,679
Multicomponent fluid diffusion houwy	April 14, 2014 09:37 by houwy	0	1,288
Change of boundary conditions during run time Alexsakowitz	April 12, 2014 02:23 by lavdwall	5	7,428
Error with reactingFoam pankajdg	April 11, 2014 16:02 by vinz	1	1,688
Foam::error::printStack(Foam::Ostream&) at ??:? Dream	April 11, 2014 02:48 by zhan	1	1,861
Could not determine array range tjliang	April 10, 2014 14:44 by nimasam	1	4,485
Solution is NOT APPROPRIATE WHEN COMPARED TO CFX adarsh tiwari	April 10, 2014 03:25 by adarsh tiwari	4	1,438
Unknown patchField type compressible::alphatWallFunction for patch type wall dante03	April 10, 2014 02:15 by hamed_m313	1	4,202
Help with OpenFoam Eli_Brazil	April 9, 2014 10:00 by blacksquirrel	4	1,911
Courant number libra	April 9, 2014 08:40 by Bernhard	8	3,396
Counterflow Turbulent diffusion Flame ssrivas3	April 8, 2014 18:02 by ssrivas3	2	2,179
coupling two solver???? mehran68	April 8, 2014 12:04 by nimasam	1	1,172
Rotating rotor inside a frame ( 1 2) wllmk1	April 8, 2014 07:58 by sam.ho	38	9,160
release a passive scalar from within the computational domain & toposet Barry	April 7, 2014 15:23 by tian	1	1,839
Unable to run tutorial "basic/laplacianFoam/flange" madhur123	April 6, 2014 15:49 by wyldckat	1	3,542
Heat transfer problem guido.bonalumi	April 5, 2014 11:09 by guido.bonalumi	0	1,005
How feasible/convenient is it to model this furnace in OpenFoam ? ankur_kr	April 4, 2014 16:36 by ankur_kr	2	2,121
time step directories naming issue Andrea_85	April 3, 2014 09:38 by alexeym	3	3,729
fluid-structure interaction with twophase fluid bieshuxuhe	April 3, 2014 00:02 by bieshuxuhe	0	1,561
how to simulate temperature field on flat plate with heating source and convection madhur123	April 1, 2014 08:14 by bieshuxuhe	1	1,259
Tank & Mixer monty86	April 1, 2014 06:42 by monty86	0	1,634
interfoam: a problem with removing convection in the air phase bieshuxuhe	March 31, 2014 23:56 by bieshuxuhe	0	1,715
Problems of bad results with LES Sunxing	March 31, 2014 06:11 by vut	10	2,172
interfoam:a problem with Air-phase convective-term treatment bieshuxuhe	March 31, 2014 03:52 by bieshuxuhe	2	1,589
Divergence only by lengthening of simulated geometry, buoyantPimpleFoam arvhult	March 29, 2014 18:03 by nsf	16	2,840
solidParticleFoam - segmentation fault mikeP	March 28, 2014 08:13 by houwy	2	1,840
Where is 'transportProperties' in the solver 'twoPhaseEulerFoam' 2.3.0? mxylondon	March 28, 2014 04:30 by mxylondon	2	1,442
Bc.S project, Heat Transfer Sumoboy	March 27, 2014 09:54 by Sumoboy	0	1,172
solver for CFD analysis of heat reduction of water in cooling tower using Openfoam? 13msmemusman	March 26, 2014 13:39 by 13msmemusman	0	1,788
Problem with INTERPHASECHANGEFOAM shipman	March 26, 2014 13:36 by vut	2	2,144
Particle size change houwy	March 26, 2014 04:47 by houwy	0	1,195
Gambit Axisymmetric Neutral File Problem SandyS	March 25, 2014 08:08 by palmerlee	4	3,834
Solver for Laminar incompressible transient flow RTom	March 24, 2014 23:51 by RTom	4	2,187
Different fluids, question lenzo	March 24, 2014 17:55 by zhengzh5	4	1,358
Poll: How to add a time dependent source term to icoFoam? kirikù	March 23, 2014 21:24 by wchen	2	2,900
Pressure Outlet boundary condition in OpenFOAM dipsar	March 23, 2014 10:59 by dipsar	0	2,003
Sensible Enthalpy brbbhatti	March 21, 2014 10:08 by dkxls	3	4,237

Read this first: How to ask a question on the forums

Page 103 of 242

103

	New posts		Hot thread with new posts
	No new posts		Hot thread with no new posts
	Thread is closed

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -4. The time now is 12:19.