|
[Sponsors] |
![]() |
![]() |
#1 |
Member
Santiago
Join Date: Dec 2009
Posts: 85
Rep Power: 16 ![]() |
Hi, I'm trying to model a fluid structure interaction using LES. I generate the turbulence at the inlet implementing a recycling technique (similar to that of Lund et all) using directMapped BC. Now, my mesh has to be able to deform, however when I run my case I get:
Create time Create dynamic mesh for time = 0 Selecting dynamicFvMesh dynamicMotionSolverFvMesh Selecting motion solver: laplaceFaceDecomposition --> FOAM FATAL ERROR: Unknown faceTetPolyPatchFaceDecomp type directMappedPatch. Valid faceTetPolyPatchFaceDecomp types are : 7 ( wall processor wedge patch empty ggi symmetryPlane ) From function faceTetPolyPatchFaceDecomp::New(const polyPatch&, const tetPolyBoundaryMeshFaceDecomp&) in file tetPolyMeshFaceDecomp/tetPolyPatches/faceTetPolyPatch/newFaceTetPolyPatchFaceDecomp.C at line 59. FOAM exiting Does this mean that deformable meshes cannot be used with DirectMapped Bc's? Do I have to set three different domains and link them together? (one recycling domain, one fluid domain with deformable mesh and one solid domain) I will appreciate any help or suggestions. Thanks |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Join Date: Jan 2010
Posts: 11
Rep Power: 16 ![]() |
Hello,
Unfortunately, I cannot help but I can report a similar error message. I'm attempting to use the regionCouple boundary in OpenFOAM-1.5-dev which throws the same error that you reported. If anyone has an idea of what we're doing incorrectly, I would certainly appreciate a pointer in the correct direction. I've been pouring over the source files to try and gain a better understanding, but I'm still stuck. Regards |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
2way FSI Fluent Mechanical SETUP Problems | MainzerKaiser | ANSYS | 7 | May 20, 2016 11:22 |
FSI problems | lingdeer | CFX | 5 | December 5, 2011 13:30 |
Needed Benchmark Problems for FSI | Mechstud | Main CFD Forum | 4 | July 26, 2011 12:13 |
how to extend FSI 2D codes to 3D, need advises | abouziar | Main CFD Forum | 1 | May 30, 2008 04:08 |