Rescaling result data

it777 · October 6, 2011, 15:42

I have done a simulation but realized my mesh was too big (my dimensions were 10^3 times greater) I have a lot of data and I am trying to avoid rerunning the whole thing with the rescaled mesh using the transformPoints command. Does anyone know if my data can be rescaled? Any help would be greatly appreciated.

Bernhard · October 6, 2011, 16:42

If your mesh is identical, except for the dimensions, I suppose you can just copy the files to the 0/ folder? However, the results will not make sense any longer.

October 6, 2011, 15:42	Rescaling result data	#1
it777 New Member Ivan Join Date: May 2011 Posts: 2 Rep Power: 0	I have done a simulation but realized my mesh was too big (my dimensions were 10^3 times greater) I have a lot of data and I am trying to avoid rerunning the whole thing with the rescaled mesh using the transformPoints command. Does anyone know if my data can be rescaled? Any help would be greatly appreciated.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
export data at nodes	Meenu	FLUENT	1	December 30, 2011 02:24
Trying to Output Data from Specific Zone (e.g. axis of symmetry) Within 2D Domain	ksiegs2	FLUENT	1	February 27, 2011 15:54
Data import in Fluent?!	Bart Horsten	FLUENT	3	February 22, 2010 14:05
XYZ (ASCII format) data points into GAMBIT	Neil	FLUENT	1	August 7, 2007 10:24
CFXSolver Error Message using Profile Data on B	Tobias	CFX	0	August 26, 2005 08:27

October 6, 2011, 16:42		#2
Bernhard Senior Member Bernhard Join Date: Sep 2009 Location: Delft Posts: 790 Rep Power: 22	If your mesh is identical, except for the dimensions, I suppose you can just copy the files to the 0/ folder? However, the results will not make sense any longer.