[claco]

Dear All,

I would like to split cyclic patches in OF 1.7.1, in order to have two patches, namely patch_half0 and patch_half1, like can be done in OF 2.0.0.
Is there an utility to do so, in Openfoam 1.7.1?

As a matter of fact, when I try to calculate mass flow rate trough a cyclic patch in OF 1.7.1, the command "patchIntegrate phi cyclic_patch" returns me a near 0 value, whereas the same command given in OF 2.0.0 ("patchIntegrate phi cyclic_patch_half0") returns me a non zero (correct) value.

I hope someone can help me.

Yours sincerely.

Claudio

[styleworker]

Probably, you solved your problem, but for the sake of completeness: http://www.openfoam.org/version2.0.0/meshing.php