Interface location problem in interFoam

cfd_user2011 · July 7, 2011, 12:28

Hello,
I am simulating capillary flow using interfoam. I am facing a strange problem. My domain size is very big. So I cannot use very big meshes. I see that if the mesh is very coarse, the interface travels faster than that for finer meshes. Is this kind of behavior expected in interfoam? Does anyone know how can we resolve this issue?

nimasam · July 7, 2011, 13:04

you should make it fine enough that result gets independent of mesh! ( means when you make it finer the results have a bit change not a big difference)

July 7, 2011, 12:28	Interface location problem in interFoam	#1
cfd_user2011 New Member Join Date: Jun 2011 Posts: 5 Rep Power: 15	Hello, I am simulating capillary flow using interfoam. I am facing a strange problem. My domain size is very big. So I cannot use very big meshes. I see that if the mesh is very coarse, the interface travels faster than that for finer meshes. Is this kind of behavior expected in interfoam? Does anyone know how can we resolve this issue?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with Interface Boundary Condition	tos	FLUENT	0	April 4, 2010 09:11
interface problem	mohamed shawky	CFX	0	January 20, 2010 20:31
InterFoam / InterDyFoam running problem	anon_c	OpenFOAM Running, Solving & CFD	1	August 26, 2009 04:54
Problem with BC on non-overlapping grid interface	Ori Levin	FLUENT	1	August 29, 2006 19:32
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 21:09

July 7, 2011, 13:04		#2
nimasam Senior Member Nima Samkhaniani Join Date: Sep 2009 Location: Tehran, Iran Posts: 1,267 Blog Entries: 1 Rep Power: 25	you should make it fine enough that result gets independent of mesh! ( means when you make it finer the results have a bit change not a big difference)