problem with paraView

tH3f0rC3 · April 21, 2011, 02:52

Hi,

sometimes after I solved a case I can't watch the result because the solved case looks like in the picture below. (Normally there are colored surfaces)

Is there a mistake in the step of solving or in the step of paraviewing?

Best Regards,
tH3f0rC3

kurne · April 21, 2011, 03:07

Hi

If the geometry is complex then the outline is came in the browser, this is due to complex geometry only what i experience.

If there is any reason then i dont know it.

tH3f0rC3 · April 21, 2011, 06:20

Hi,

Ok, the complex geometry can be a reason.
But I can view the same model solved with chtMultiRegionSimpleFoam.

Tobi · April 21, 2011, 06:39

Quote:

Originally Posted by tH3f0rC3

Hi,

Ok, the complex geometry can be a reason.
But I can view the same model solved with chtMultiRegionSimpleFoam.

Hi Dirk,

you have to put the "outline" to - > "surface" then you got your display.

If the mesh and geometry is large (size), paraview uses the Outlines as a standard preferences.

Tobi

tH3f0rC3 · April 21, 2011, 06:52

That's it!
Thank you! :-)

tH3f0rC3

April 21, 2011, 03:07		#2
kurne Member Kurne Join Date: Aug 2010 Location: Pune, INDIA Posts: 88 Rep Power: 16	Hi If the geometry is complex then the outline is came in the browser, this is due to complex geometry only what i experience. If there is any reason then i dont know it. __________________ Simulation Is Determination Of Imagination Towards Approximation ® Best Regards Mubeen K Kurne

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with Paraview	ata	OpenFOAM	10	August 6, 2011 04:21
[OpenFOAM] Installation problem with ParaView 3.8.0 on openSUSE 11.2	aero_	ParaView	14	August 2, 2010 19:13
problem with new OF170 paraview instalation	anmartin	OpenFOAM Installation	3	June 29, 2010 19:29
Yet another Paraview problem	gascortado	OpenFOAM	5	February 21, 2010 07:39
[OpenFOAM] Problem with Colors in ParaView	sven	ParaView	1	May 31, 2009 09:13

April 21, 2011, 06:20		#3
tH3f0rC3 Senior Member Join Date: Mar 2011 Posts: 158 Rep Power: 15	Hi, Ok, the complex geometry can be a reason. But I can view the same model solved with chtMultiRegionSimpleFoam.

April 21, 2011, 06:52		#5
tH3f0rC3 Senior Member Join Date: Mar 2011 Posts: 158 Rep Power: 15	That's it! Thank you! :-) tH3f0rC3