|
[Sponsors] |
???????simulate heat distribution in an incompressibe laminar steady state flow?????? |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
Maryam Mousazadeh
Join Date: Oct 2010
Posts: 47
Rep Power: 15 ![]() |
Hi,
I want to simulate heat distribution in an incompressibe laminar steady state flow. I thinke, I should add energy equation to simpleFoam. is there other solver or other way to do this as esear than adding energy equation to simpleFoam ? thanks |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Member
Alan Russell
Join Date: Aug 2009
Location: Boise, Idaho USA
Posts: 61
Rep Power: 17 ![]() |
Take a look at the heat transfer tutorials. BuoyantSimpleFoam adds the energy equation to simpleFoam - and the hotRoom tutorial models laminar convective heat transfer (surface to air). Also look through the other heat transfer solvers and tutorials to see if there is a better fit for your model.
Alan |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Laminar flow and wall roughness | junbbung | FLUENT | 2 | November 26, 2022 21:22 |
initialization of flow field to enhance convergence rate to steady state | vfico | Main CFD Forum | 0 | September 9, 2009 11:23 |
Laminar field as initial state for turbulent two phase pipe flow | kjetil | OpenFOAM Running, Solving & CFD | 3 | July 21, 2009 09:15 |
Steady state transsonic turbulent flow | kvick | OpenFOAM Running, Solving & CFD | 2 | February 12, 2009 04:36 |
About the difference between steady and unsteady problems | Lisa | Main CFD Forum | 11 | July 5, 2000 14:37 |