|
[Sponsors] |
adapt offset cylinder model for les turbulence |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Charlie
Join Date: Aug 2010
Posts: 14
Rep Power: 16 ![]() |
I am trying to adapt the offsetCylinder mesh to work with a les turbulent model. As of now I have created a new folder combining the mesh from offset cylinder and the 0 and system folders from the pisoFoam les model (incompressible). The code can generate the mesh through blockmesh, but when I run the code using the pisoFoam solver I get the following error.
keyword left is undefined in dictionary "home/...../lescylinder/0/p: :boundaryField" I looked at the P file and there is no "left" term found. I believe this is created from the (non-congruent) constant and 0 system files but I am not sure. Any advise would be much appreciated. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Use of k-epsilon and k-omega Models | Jade M | Main CFD Forum | 40 | January 27, 2023 07:18 |
Modified k-e turbulence model UDF | Travis | Fluent UDF and Scheme Programming | 7 | November 11, 2018 20:21 |
question about turbulence model selection and sensitivity | karananand | Main CFD Forum | 1 | February 26, 2010 04:41 |
Centrifugal Pump and Turbulence Model | Michiel | CFX | 12 | January 25, 2010 03:20 |
SSG Reynolds Turbulence Model | Georges | CFX | 1 | February 28, 2007 16:15 |