Making avi-file in ParaView

Aleksey_R · December 24, 2009, 19:36

Hello, colleagues!
Please, help me. How to make avi-file in ParaView? I've made an animation, I can save it in jpeg, png, etc. BUT NOT IN AVI! There isn't such menu choice. But accoridong to ParaView manual there should be.
Best regards, Aleksey.

openfoam1 · December 25, 2009, 03:09

Hello Aleksey :

I think the output of paraview is only photos not avi
you can change the photos to animations very easy using any software you like ,, you may use that one

http://www.aswsoftware.com/products/...agetoavi.shtml

regards

FG_HSRM · December 25, 2009, 09:33

Hello Aleksey,

the mplayer with mpeg4 codec works fine for me and is easy to handle over command line.

mencoder mf://\*.jpg -mf w=800:h=600:fps=10:type=jpg -ovc lavc -lavcopts vcodec=mpeg4 -oac copy -o output.avi

regards

December 24, 2009, 19:36	Making avi-file in ParaView	#1
Aleksey_R Member Aleksey Rukhlenko Join Date: Nov 2009 Location: Moscow Posts: 55 Rep Power: 17	Hello, colleagues! Please, help me. How to make avi-file in ParaView? I've made an animation, I can save it in jpeg, png, etc. BUT NOT IN AVI! There isn't such menu choice. But accoridong to ParaView manual there should be. Best regards, Aleksey.

December 25, 2009, 09:33		#3
FG_HSRM Member Join Date: Dec 2009 Posts: 36 Rep Power: 17	Hello Aleksey, the mplayer with mpeg4 codec works fine for me and is easy to handle over command line. mencoder mf://\.jpg -mf w=800:h=600:fps=10:type=jpg -ovc lavc -lavcopts vcodec=mpeg4 -oac copy -o output.avi regards Last edited by FG_HSRM; December 25, 2009 at 10:19.*

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Convection discretization schemes for LES	sek	OpenFOAM Running, Solving & CFD	38	July 31, 2017 15:30
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 14:43
[Gmsh] Compiling gmshFoam with OpenFOAM-1.5	BlGene	OpenFOAM Meshing & Mesh Conversion	10	August 6, 2009 05:26
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 15:00
Results saving in CFD	hawk	Main CFD Forum	16	July 21, 2005 21:51

December 25, 2009, 03:09		#2
openfoam1 Member Join Date: Dec 2009 Posts: 46 Rep Power: 17	Hello Aleksey : I think the output of paraview is only photos not avi you can change the photos to animations very easy using any software you like ,, you may use that one http://www.aswsoftware.com/products/...agetoavi.shtml regards