|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
SATORU ESASHI
Join Date: Dec 2009
Posts: 4
Rep Power: 16 ![]() |
Hi,
Now, I have calculated 3D model of approximately one million. However, as computer's memory is 2GB, calculated time puts in many times. Therefore, I think I try to do parallelization calculation. So, could you tell me how to do parallelization calculation by OpenFOAM? Please tell me as specifically as possible. e.g OS of destination must be connected to linux by linux, cable is LAN cable, how to operate software and so on. In fact, Now I use OpenFOAM-1.5 and linux. In addition, I try to use openmpi. but, I can't install it. After I did './configure' ,error (configure:error: in "home/user1/openmpi1-4" configure:error C compiler create executables See "config.log" for more details.) was displayed. Now, compilar use GCC 4.2.1. Could also tell me it? Regards! Last edited by SARU; December 16, 2009 at 11:26. Reason: Because I can make gradual progress a little to do parallel calculation. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to continue calculation after the computer is abruptly shut off? | superqtp | CFX | 5 | September 25, 2012 08:53 |
The calculation efficiency of OpenFOAM | chiven | OpenFOAM Running, Solving & CFD | 4 | September 14, 2009 04:44 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Rotation flow calculation. | Hans | FLUENT | 0 | March 31, 2003 06:03 |
Heat Flux Calculation under REPORTS | Alberto Schroth | FLUENT | 0 | May 16, 2000 08:19 |