 |
 |
 |
|
|
|
[Sponsors] | ||||
January 11, 2024, 07:16
|
pimplefoam simulation is exploding
|
#1 |
|
New Member
BK
Join Date: Jan 2024
Posts: 2
Rep Power: 0  |
Hi Foamers,
I am a new foamer, I try to simulate an aircraf propeller. The simulation explodes after adding layer. Instead of adding layer, I tried increasing the mesh refinement but but it explodes again. In this case, is the problem in boundary conditions? or mesh problem? Sincerely |
|
|
|
|
 |
| Tags |
| layer addition, openfoam, pimplefoam, propeller convergence |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Running pimpleFoam in steady state | trailer | OpenFOAM Running, Solving & CFD | 6 | January 24, 2023 04:07 |
| Problem running pimpleFoam in magnus effect simulation | boffin5 | OpenFOAM Running, Solving & CFD | 1 | June 15, 2021 15:53 |
| write bc data and read it for other simulation | jdp810 | SU2 | 1 | May 8, 2021 18:04 |
| Low permeability medium simulation using pimpleFoam | Caio Martins | OpenFOAM Running, Solving & CFD | 0 | August 18, 2016 20:39 |
| pimpleFoam deltaT increases rapidly running TJunction like simulation? | massive_turbulence | OpenFOAM Running, Solving & CFD | 8 | April 24, 2014 22:09 |
Linear Mode
