|
[Sponsors] |
Free Heave-Decay Simulation Failure using waveDyMFoam Solver |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 14, 2023, 03:25 |
Free Heave-Decay Simulation Failure using waveDyMFoam Solver
|
#1 |
New Member
Haider
Join Date: Feb 2023
Posts: 20
Rep Power: 3 |
Dear OpenFOAM Community,
I am facing a critical issue with my free heave-decay simulation of a 2D-cylinder using the waveDyMFoam solver. The simulation fails after the fourth iteration, and I am unable to determine the cause of the error. Please find the attached screenshot of the error for your reference. I kindly request your immediate assistance and expertise to help resolve this problem. Any insights, suggestions, or guidance you can provide would be greatly appreciated. Thank you in advance for your prompt attention and support. Best regards, Haider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error SIGSEGV using VOF and UDF | JERC_UTFSM | Fluent UDF and Scheme Programming | 14 | November 7, 2021 23:17 |
Does rhoSimpleFoam solver impose a velocity field divergence free? | MastaMinds | OpenFOAM Running, Solving & CFD | 1 | June 20, 2021 13:08 |
solver selection_dynamic mesh_leak simulation | nikhil108 | Main CFD Forum | 1 | August 13, 2020 17:17 |
Problem with an old Simulation | FrankW | CFX | 3 | February 8, 2016 04:28 |
How can I use solution from one simulation as initial condition on a remote solver? | Dano62 | CFX | 0 | October 21, 2015 17:45 |