|
[Sponsors] |
Using Adaptive mesh refinement (AMR) under partial slip conditions. |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Huanlei Zhao
Join Date: Feb 2022
Posts: 3
Rep Power: 4 ![]() |
Dear all,
I am going to use Adaptive mesh refinement (AMR) under the partial slip condition in OpenFOAM-v2006. In AMR, the grid size will be changed, i.e. refined or unrefined during the simulation. However, the slip length is influenced by the size of the grid adjacent to the wall in the partial slip condition (please see the attachment). Therefore, when the grid adjacent to the wall is refined, the slip length may be changed too. My question is if the slip length varies when using AMR? If the answer is yes, is there a way to fix the slip length when using AMR? Thanks! Kind regards. Zhao |
|
![]() |
![]() |
![]() |
Tags |
adaptive mesh refinement, slip condition |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adaptive Mesh Refinement (AMR) on OF v10 | manahara | OpenFOAM Running, Solving & CFD | 1 | October 20, 2022 02:27 |
problem with parallel calculations OF8 mpirun | otaolafr | OpenFOAM Programming & Development | 0 | January 5, 2021 07:33 |
AMR - adaptive mesh refinement STAR-CCM+ | diggian | STAR-CCM+ | 9 | December 1, 2020 14:13 |
[snappyHexMesh] Not Able to Refine Mesh in Refinement Box | noodleluvmay | OpenFOAM Meshing & Mesh Conversion | 2 | January 27, 2020 10:55 |
[snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 17:16 |