|
[Sponsors] |
January 10, 2023, 09:02 |
condensation not only take place at the wall
|
#1 |
New Member
lee
Join Date: Dec 2022
Posts: 1
Rep Power: 0 |
Hello everyone,
I'm using the interCondensatingEvaporatingFoam to simulate a 2D condensation case. The water vapor condenses on a tube. However, the condensation not only takes place on the tube, but also in the air. Does anyone knows how to fixed it? the up boundary is set pressureinletoutlet, left and right are cyclic and the bottom is a wall. the tube is in the middle of the computation domin. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Model of air–steam flow with condensation into the volume and surface wall | gartz89 | FLUENT | 0 | February 9, 2022 23:44 |
Ansys CFD-Post Application Error | rushiCFD | FLUENT | 0 | March 21, 2021 07:51 |
Condensation on wall | Imtisal-e-Noor | FLUENT | 0 | April 27, 2017 09:18 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
[Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh | Shoonya | OpenFOAM Meshing & Mesh Conversion | 11 | January 20, 2012 06:23 |