 |
 |
 |
|
|
|
[Sponsors] | ||||
February 21, 2022, 17:52
|
CyclicAMI Error
|
#1 |
|
Senior Member
Sakun
Join Date: Nov 2019
Location: United Kingdom
Posts: 152
Rep Power: 7  |
Hi all,
I am trying to simulate compressor cascade using kOmegaSST. as for the mesh generation i am using ansys ICEM then convert that mesh into openFOAM format. As i shown in the "Geomatry and boundary condition layout" picture TOP and BOTTOM boundary conditions are "Periodic" . For that i changed TOP and BOTTOM conditions as "cyclicAMI" (as shown in the Boundary file picture) in the boundary file. after i run the simpleFoam commad, i got an error saying "Unable to set target face for source face 471" (cyclicAMI Error picture) Please guide me to correct this error. Thank you. |
|
|
|
|
 |
| Tags |
| cyclic ami, cyclic boundary condition, cyclicami |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 01:21 |
| [blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 10:00 |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 19:00 |
| OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 10:17 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 18:51 |
Linear Mode
