 |
 |
 |
|
|
|
[Sponsors] | ||||
July 12, 2021, 23:47
|
displacement height in atmBoundaryLayer
|
#1 |
|
New Member
Joćo Pedro
Join Date: May 2019
Posts: 4
Rep Power: 7  |
Hello everyone,
Im currently working on simulations of the atmospheric boundary layer using OpenFOAM 20.12. One of the inputs for the "atmBoundaryLayer" boundary condition is the Displacement Height "d". I wonder if is possible to insert a non-uniform value to this parameter? Since it's type is "PatchFunction1<scalar>" (acording to: https://www.openfoam.com/documentati...daryLayer.html). If so, how can i do it based on the "intersection" of the inlet face with my geometry (in this case, the terrain)? Thanks in advance, Joćo |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 08:48 |
| snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 11:58 |
| [snappyHexMesh] determining displacement for added points | CFDnewbie147 | OpenFOAM Meshing & Mesh Conversion | 1 | October 22, 2013 10:53 |
| how to use Total Mesh Displacement for making a subject translating and rotating? | snailstb | CFX | 3 | September 16, 2009 05:06 |
| height & displacement | azmir | Siemens | 8 | February 4, 2005 05:54 |
Linear Mode
