 |
 |
 |
|
|
|
[Sponsors] | ||||
Adding pressure as boundary condition in dsmcFoam |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 30, 2021, 06:38
|
Adding pressure as boundary condition in dsmcFoam
|
#1 |
|
New Member
Usama Niaz
Join Date: Oct 2019
Location: Pakistan
Posts: 7
Rep Power: 7  |
Hi Foamers,
I have been working with dsmcFoam lately, the problem I am working on requires imposing pressure difference between inlet and outlet, however, there is no such file in 0 folder, so is it possible to add one through editing in source code? furthermore while writing the logFile, it writes each timestep, which makes the file quite heavier to load, is there any way that only at the time specified in writeInterval, it writes the logFile? Regards Niazi |
|
|
|
|
|
| Tags |
| dsmcfoam, openfoam, runfunction |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| Appropriate pressure boundary condition in incompressible flow | lonelywing | OpenFOAM Running, Solving & CFD | 21 | June 6, 2022 10:44 |
| Total Pressure boundary condition in the OpenFOAM | dli | OpenFOAM Programming & Development | 1 | December 6, 2017 00:16 |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 18:38 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
Linear Mode
