 |
 |
 |
|
|
|
[Sponsors] | ||||
February 11, 2021, 09:02
|
Small Inlet
|
#1 |
|
New Member
Tiago
Join Date: Feb 2021
Posts: 2
Rep Power: 0  |
I am a university student, and I have been having a technical problem. For my master thesis I am using Helyx-os to generate the mesh, however I have a problem in one of the geometries. When I go to mesh my inlet has is a quarter circle with a radius of 0.8mm and so I need a very small base mesh spacing but as I only have 1gb of memory available, when I reduce the base mesh spacing of the kill process, how could I increase the available memory, if that is the problem of the inlet not appearing in the mesh.
|
|
|
|
|
 |
| Tags |
| helyx-os, inlet |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OLAFLOW] The OLAFLOW Thread | Phicau | OpenFOAM Community Contributions | 459 | September 12, 2024 12:47 |
| Problem with assigned inlet velocity profile as a boundary condition | Ozgur_ | FLUENT | 5 | August 25, 2015 05:58 |
| How to set up the inlet boundary condition for a low pressure case? | beastieboys6 | FLUENT | 3 | April 10, 2012 23:46 |
| [TGrid] Inlet passage in turbogrid. | soldimix15 | ANSYS Meshing & Geometry | 0 | September 5, 2010 12:34 |
| Inlet table in STAR-CD | Sachin | Siemens | 1 | March 26, 2008 11:22 |
Linear Mode
