|
[Sponsors] |
June 2, 2020, 11:25 |
Smearing of volume fraction in contact line
|
#1 |
New Member
Yağmur GÜLEÇ
Join Date: May 2014
Posts: 9
Rep Power: 12 |
Dear All,
I am using VOF method with a phase change model using MULES in OpenFOAM. MULES::explicitSolve(geometricOneField(), alpha1, phi, phiAlpha, alphaSourceSp, alphaSourceSu, 1, 0); Source terms : alphaSourceSu = fvc::div(phi)*alpha1; alphaSourceSp = fvc::div(phi)*0.0; On the contact line I use contact angle boundary condition type constantAlphaContactAngle; gradient uniform 0; limit zeroGradient; theta0 40; value uniform 0; But there is a problem of smearing in the contact line at an increasing rate with time as seen in the attachment. Is it usual to experience in MULES scheme or can it be due to another problem which can be related to setting of contact angle boundary condition? Thanks in advance, Best Regards, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] Errors during blockMesh meshing | Madeleine P. Vincent | OpenFOAM Meshing & Mesh Conversion | 51 | May 30, 2016 10:51 |
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |