 |
 |
 |
|
|
|
[Sponsors] | ||||
April 27, 2019, 08:20
|
Question about boundary conditions
|
#1 |
|
Member
Joe lee
Join Date: Nov 2018
Posts: 59
Rep Power: 8  |
Hi Foamers, I would like to understand the boundary conditions settings, through the motorBike tutorials.
For the front, back and upper walls, they are defined as patch type in blockMeshDict, and being slip type in U.orig, p, k and omega. Does this simply mean these three walls are open, and when the fluid is incoming from the inlet, the fluid can escape from not only the outlet, but also these three walls? Thank you very much. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 14:55 |
| Implementation of boundary conditions for FVM | Tom | Main CFD Forum | 7 | August 26, 2014 06:58 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
| question about implementing boundary conditions | saygin | Main CFD Forum | 0 | July 6, 2006 08:08 |
Linear Mode
