|
[Sponsors] |
![]() |
![]() |
#1 |
Member
Join Date: May 2017
Posts: 44
Rep Power: 9 ![]() |
Dear Foamers,
I added a source term to pressure equation at the interface in interFoam as follows: fvScalarMatrix p_rghEqn ( fvm::laplacian(rAUf, p_rgh) == fvc::div(phiHbyA)+pTerm ); pTerm is attached. I observed the attached pressure distribution. Both pTerm and pressure are at the first timestep. Pressure and velocity boundary conditions are attached. I am wondering if this behaviour makes sense or I should observe the pressure change only around interface. Many thanks, |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Source Term due to evaporation in energy transport equation | styleworker | OpenFOAM Programming & Development | 3 | September 7, 2022 03:09 |
what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 01:22 |
[swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
[swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
friction forces icoFoam | ofslcm | OpenFOAM | 3 | April 7, 2012 10:57 |