 |
 |
 |
|
|
|
[Sponsors] | ||||
October 11, 2017, 16:02
|
Inlet - totalPressure BC (CFX vs OpenFOAM)
|
#1 |
|
Senior Member
cyln
Join Date: Jul 2016
Posts: 102
Rep Power: 10  |
Hello,
I am reproducing some CFD results using OpenFoam. The previous study has been done using CFX. In CFX, the inlet was set as follows: Total Pressure (Stable) Relative Pressure: 0 Pa How can I set the same type of BC in OpenFOAM? I know there is a totalPressure BC but I do not know how to set relative pressure. Cheers |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| prescribing inlet for OpenFOAM | saeedi | OpenFOAM Pre-Processing | 5 | September 8, 2015 12:21 |
| New OpenFOAM Forum Structure | jola | OpenFOAM | 2 | October 19, 2011 07:55 |
| CFX problems with supersonic inlet condition - Inlet values in CFX-Post are wrong | jannnesss | CFX | 5 | February 25, 2011 17:24 |
| Cross-compiling OpenFOAM 1.7.0 on Linux for Windows 32 and 64bits with Mingw-w64 | wyldckat | OpenFOAM Announcements from Other Sources | 3 | September 8, 2010 07:25 |
| ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 16:45 |
Linear Mode
