 |
 |
 |
|
|
|
[Sponsors] | ||||
How to simulate a virtual duct in a car model? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 19, 2017, 04:15
|
How to simulate a virtual duct in a car model?
|
#1 |
|
Member
Join Date: Nov 2014
Posts: 92
Rep Power: 12  |
Hello Foamers,
I am now working on optimizing a vehicle external aerodynamics. I would like to simulation how a duct connecting the bottom and rear of the vehicle will affect the performance. I first do a preliminary study on the position of the duct inlet and outlet before modifying the model. I create two stl files for the inlet and outlet and I am going to use fan BC for simulating the pressure drop. However I am struggling of how can I apply the BC and patch in the sim. I follow the TJuntcionFan tutorial to define the patch with topoSet. My question is after defining the patch where should I assign the fan BC on the patch and how should it be set? Thank you very much Last edited by hokhay; September 19, 2017 at 07:33. |
|
|
|
|
|
September 24, 2017, 15:07
|
|
#2 |
|
Member
Join Date: Nov 2014
Posts: 92
Rep Power: 12 |
||
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Calculation of Coefficient of Drag of simplified car model. | gshankarau | FLUENT | 0 | July 17, 2015 03:45 |
| DrivAer car model Convergence | MarkT | FLUENT | 0 | April 21, 2015 11:23 |
| Overflow Error in Multiphase Modelling with Two Continuous Fluids | ashtonJ | CFX | 6 | August 11, 2014 15:32 |
| What Viscous Model for a pressure variation to the inlet of a duct? | guillaume1990 | FLUENT | 1 | March 12, 2014 04:31 |
| How i can to simulate the air flow over the car? | fernando vicente | CFX | 3 | August 11, 2003 23:35 |
Linear Mode
