|
[Sponsors] |
December 3, 2016, 10:47 |
How can you design a Abrams cone in Openfoam
|
#1 |
New Member
Mrin
Join Date: Dec 2016
Posts: 1
Rep Power: 0 |
I am an openfoam beginner and I have to design a Abrams cone which is a cone with the top part cut, so the top radius is 50 mm and the bottom diameter is 100 mm and the height is 300 mm. And I have to mesh it. How do I go about this? How will this show on Paraview?
|
|
December 4, 2016, 07:33 |
|
#2 |
Super Moderator
Tobias Holzmann
Join Date: Oct 2010
Location: Bad Wörishofen
Posts: 2,711
Blog Entries: 6
Rep Power: 52 |
There are several possibilities for you:
__________________
Keep foaming, Tobias Holzmann |
|
Tags |
openfoam 2.0.x, paraview |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM 4.0 Released | CFDFoundation | OpenFOAM Announcements from OpenFOAM Foundation | 2 | October 6, 2017 06:40 |
OpenFOAM Training, London, Chicago, Munich, Houston 2016-2017 | cfd.direct | OpenFOAM Announcements from Other Sources | 0 | September 14, 2016 04:19 |
OpenFOAM v3.0.1 Training, London, Houston, Berlin, Jan-Mar 2016 | cfd.direct | OpenFOAM Announcements from Other Sources | 0 | January 5, 2016 04:18 |
OpenFOAM Foundation releases OpenFOAM® 3.0.0 | CFDFoundation | OpenFOAM Announcements from OpenFOAM Foundation | 1 | November 7, 2015 16:16 |
Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 11:18 |