[Tobi]

Dear Foamers,

during the weekend I started a new project and meshed a nice and smooth carburetto as a test case for snappyHexMesh.

Therefor I could check several settings:

• 2D mesh generation with sHM (extrude from patch)
• snap settings
• layersettings

Hence the mesh and the geomtry are so nice, I thought about using this smooth 2d geometry for a simulation.


First of all I wanted to fill the carburetto with fuel (interFoam) and after that simulating a engine on the inlet patch, so that fuel and air should mix.

The question therefor is, which solver would be a good one?
Its just playing around with OpenFOAM and other tools but it would be nice to do it.

Is there any solver recommended for such a simulation?
Regards
Tobi