|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
nrw
Join Date: Apr 2014
Posts: 1
Rep Power: 0 ![]() |
Hello I m new to both linux and openfoam so I have few doubts in running the simulation.
For my simulation I need some supporting libraries to be installed but I m not sure about the procedure. So my directory contrains 0 constant and system subdirectories. So if ihave to instal my libraries which directory should I have do install so my simulation runs??? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,978
Blog Entries: 45
Rep Power: 128 ![]() ![]() ![]() ![]() ![]() ![]() |
Greetings pooja_m21 and welcome to the forum!
OpenFOAM is a toolbox, which usually means one should install it completely, in order to use it. For that, follow the usual installation instructions: http://www.openfoam.org/download/ - or check this thread: Frequently Asked Questions about Installing OpenFOAM Once OpenFOAM is installed, read/study the OpenFOAM User Guide and do the tutorials: http://www.openfoam.org/docs/user/ Best regards,Bruno
__________________
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Exporting data of transient simulation DURING a simulation, at user locations ? | Milan2013 | CFX | 0 | April 18, 2014 03:47 |
Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 10:44 |
GUI crash and simulation engine still running | RPJones | FLOW-3D | 2 | November 9, 2010 08:18 |
strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 13:02 |
help for Large eddy simulation | Randheer Yadav | FLUENT | 0 | July 27, 2005 16:38 |