|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Daniel Johannesson
Join Date: Mar 2014
Posts: 1
Rep Power: 0 ![]() |
Hello everyone
I have some problem with building a model for my project. The model can be in 2D and consists of 3 blocks. Two of them is water and one is a isolation material. I want to see how water gets cooled down by water on the other side of the isolating material. So the case is much like this model. How can i modify this to simulate the case I want? I use OpenFOAM 2.3.0 and I know how to edit the properties of the blocks, in planeWall2D it is two blocks of air and a concrete wall, but I need two stationary water-blocks with e.g iron between them to simulate a pipe. Is there some modification that needs to be done to fvSchemes and fvSolution? Any help would be appreciated. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat Transfer mechanisms | tafaugl | CFX | 1 | November 7, 2012 18:46 |
Heat Transfer | ahmed_khatibs | OpenFOAM | 2 | March 20, 2012 04:43 |
Heat Flux at wall in a conjugate heat transfer problem | Chander | CFX | 2 | July 9, 2011 22:22 |
MRF and Heat transfer calculation | Susan YU | FLUENT | 0 | June 2, 2010 08:46 |
Convective / Conductive Heat Transfer in Hypersonic flows | enigma | Main CFD Forum | 2 | November 1, 2009 22:53 |