|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: May 2013
Posts: 6
Rep Power: 13 ![]() |
Hello Foamers,
I am writing this today as I need a little help in deciding what computer to buy. I am relatively new to OF and I would like to use it for the following applications: - importing cad drawings and subsequent meshing of offshore platforms - Ventilation studies - Gas dispersion - Fire modelling From experience it seems that the number of cells required lies between 2 and 5 millions. I am not a computer expert by any stretch of the imagination so would like your feedback based on two possible options. Let it be told that I cannot build a machine by myself and my budget is around the £2,000.00 mark. Option 1) http://configure.us.dell.com/dellsto...en&s=bsd&cs=04 Option 2) http://www.meshcomputers.com/Default...omepage_dtbox2 I would greatly appreciate your feedback on these options and any tweaks required to make the most of my simulations. Thank you for your time Falstaff |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
|
||
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Join Date: May 2013
Posts: 6
Rep Power: 13 ![]() |
Sorry for misplacing this. Thanks for the pointers.
Regards |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |