|
[Sponsors] |
July 7, 2013, 03:38 |
heat transfer problem
|
#1 |
Member
subhendu
Join Date: Jun 2013
Location: kolkata,india
Posts: 39
Rep Power: 13 |
i used hot room case from buoyantSimpleFoam but there is a problem in floux outflow ,i am new to openfoam
Continuity error cannot be removed by adjusting the outflow. Please check the velocity boundary conditions and/or run potentialFoam to initialise the outflow. Total flux : 5.88023e+06 Specified mass inflow : 21.4527 Specified mass outflow : 0 Adjustable mass outflow : 0 From function adjustPhi(surfaceScalarField& phi, const volVectorField& U,const volScalarField& p in file cfdTools/general/adjustPhi/adjustPhi.C at line 118. FOAM exiting |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat transfer problem at nucleate boiling | MrStuebb | FLUENT | 12 | March 14, 2017 13:31 |
Natural Convection heat transfer problem | srinivasa | FLUENT | 21 | November 11, 2016 06:08 |
Wall heat transfer coefficient (HTC) problem | Mohamed khamis | CFX | 1 | January 15, 2010 23:12 |
How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 18:53 |
Heat Transfer Problem Help | JB | FLUENT | 2 | October 18, 2006 18:54 |