 |
 |
 |
|
|
|
[Sponsors] | ||||
August 12, 2012, 09:06
|
Mixed Convection BCs
|
#1 |
|
Senior Member
n/a
Join Date: Sep 2009
Posts: 199
Rep Power: 17  |
Good day to the OpenFOAM forum posters. I ran into a problem pertaining to the correct way of prescribing velocity and pressure boundary conditions for a turbulent mixed convection boundary layer flow over a vertically heated flat plate. I think the issue might be the way the inlet pressure BCs is defined, but I have not found any solution that works. The goal is to feed a uniform velocity of 1 m/s in the vertical direction. The simulation diverges after a few seconds. Any feedback would be greatly appreciated.
Cheers, Deji |
|
|
|
|
|
August 20, 2012, 17:09
|
|
#2 |
|
Senior Member
n/a
Join Date: Sep 2009
Posts: 199
Rep Power: 17 |
So there's no one that can give me any feedback on this problem?
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mixed Convection Inflow BC ?? | deji | OpenFOAM | 3 | June 6, 2012 18:09 |
| Modeling both radiation and convection on surfaces - Ansys Transient Thermal R13 | s.mishra | ANSYS | 0 | March 31, 2012 05:12 |
| need help - mixed convection in vertical duct | vetnav | OpenFOAM | 0 | May 3, 2010 18:40 |
| mixed convection and radiation through ducts | vijay | FLUENT | 1 | May 16, 2008 03:16 |
| Free convection BCs | Craig Hildreth | CFX | 1 | February 24, 2008 17:45 |
Linear Mode
